HM/DMMI/UL

อุปกรณ์โมดูลตรวจสอบแบบสองสาย สำหรับสัญญาณเตือนอัคคีภัยแบบสัมผัส Honeywell Morley

The HM-DMMI-UL Monitor Module is intended for use in intelligent, two-wire systems, where the individual address of each module is selected using the built-in rotary switches. It provides either a two-wire or four-wire fault-tolerant Initiating Device Circuit (IDC) for normally open, contact fire alarm and supervisory devices. The module has a panel-controlled LED indicator.

HM-DMMI-UL Applications: Monitor a zone of four-wire smoke detectors, manual fire alarm pull stations, waterflow devices, or other normally open, drycontact alarm activation devices. Use it to monitor normally-open supervisory devices with special supervisory indication at the control panel. The monitored circuit may be wired as an NFPA (Class B) Initiating Device Circuit. A 47K Ohm end of line resistor (provided) terminates the Class B circuit.

HM-DMMI-UL Operation: Each HM-DMMI-UL uses one of the available module addresses on an SLC loop. It responds to regular polls from the control panel and reports its type and the status (open/normal/short) of
its Initiating Device Circuit (IDC). A flashing LED indicates that the module communicates with the control panel. The LED steadily illuminates when an alarm starts (subject to current loop limitations).

  • Built-in type identification automatically identifies this device as a monitor module to the control panel
  • Powered directly by two-wire SLC loop. No additional power required
  • High noise (EMF/RFI) immunity
  • SEMS screws with clamping plates for easy wiring
  • Direct-dial entry of address: 61-99 for models SMX and STX
  • LED flashes during normal operation and steadily illuminates to indicate alarm

HM-DMMI-UL TECHNICAL SPECIFICATIONS

Nominal Operating Voltage15 to 32 VDC
Maximum SLC current draw5.0 mA (LED on)
Maximum IDC wiring resistance375 μA (LED flashing), 1 communication every 5 seconds, 47k EOL
Maximum IDC wiring resistance1500 Ohms
Maximum IDC Voltage11 V
EOL resistance47K Ohms
Temperature range32°F to 120°F (0°C to 49°C)
Humidity range10% to 93% non-condensing
Dimensions4.5″ (11.43 cm) high x 4″ (10.16 cm) wide x 1.25″ (3.175 cm) deep. Mounts to a 4″ (10.16 cm) square x 2.125″ (5.398 cm) deep boxS